Hai bisogno di aiuto veloce? Chiamata 1-800-LEE-PLUG

Microidraulica Industriale

Introduction

A gas flowing through an orifice is throttled (causing turbulence and heating), and expanded (causing cooling). Thus, it is subject to energy conversions which reduce the amount of energy available to do work. The rate at which available energy is lost can be termed the pneumatic power, which is a function of the pressures, Lohm rate of the orifice, and the flow. For nitrogen, the relationship is shown on the accompanying graph.

When the flow rate and pressure ratio is known, the resulting power consumption can be determined from the graph. If flow is not known, it can be readily calculated from the Lohm rate using the gas Lohm Law. Simply enter the graph at the appropriate pressure ratio (X-axis), and read vertically to the line corresponding to the applicable flow rate. The resulting power may then be read horizontally across on the Y-axis. Note that pressure ratio is the ratio of the absolute pressures.

For more precise calculations, or to extend the range of the pneumatic power graph, the following formula may be used for nitrogen or air.


 

Note that due to compressor inefficiencies, more power will be needed to compress the gas than will be expended when it flows through an orifice.

A gas flowing through an orifice is throttled (causing turbulence and heating), and expanded (causing cooling). Thus, it is subject to energy conversions which reduce the amount of energy available to do work. The rate at which available energy is lost can be termed the pneumatic power, which is a function of the pressures, Lohm rate of the orifice, and the flow. For nitrogen, the relationship is shown on the accompanying graph.

When the flow rate and pressure ratio is known, the resulting power consumption can be determined from the graph. If flow is not known, it can be readily calculated from the Lohm rate using the gas Lohm Law. Simply enter the graph at the appropriate pressure ratio (X-axis), and read vertically to the line corresponding to the applicable flow rate. The resulting power may then be read horizontally across on the Y-axis. Note that pressure ratio is the ratio of the absolute pressures.

For more precise calculations, or to extend the range of the pneumatic power graph, the following formula may be used for nitrogen or air.


 

Note that due to compressor inefficiencies, more power will be needed to compress the gas than will be expended when it flows through an orifice.